What to do if my Hilti Drill doesn't start?
If your Hilti Drill isn't starting, the issue might be an interruption in the electric supply. To resolve this, try plugging in another electric tool or appliance to the same outlet to see if it works. This will help you determine if the problem lies with the power outlet itself.
What to do if my Hilti Drill bit makes no progress?
If your Hilti Drill bit isn't making any progress, it's possible that the power tool has been set to reverse rotation. To fix this, simply set the power tool to forward rotation.
How to release a stuck drill bit from my Hilti Drill?
If you're having trouble releasing the drill bit from your Hilti Drill, the chuck might not be pulled back fully. Make sure to pull the chuck back as far as it will go and then try removing the accessory tool.
Why is there no hammering action on my Hilti Drill?
There could be a couple of reasons why you're not getting any hammering action from your Hilti Drill. First, the power tool might be too cold; in this case, bring the tip of the drill bit into contact with the working surface, switch the rotary hammer on and allow it to run. If necessary, repeat the procedure until the hammering mechanism begins to operate. Alternatively, the function selector switch might be set to “Drilling without hammering.” Ensure it is set to the (drilling with hammering action, i.e. hammer drilling) setting.
How to improve the power of my Hilti Drill?
If your Hilti Drill isn't achieving full power, check the following: the gauge (cross section) of the extension cord conductors may be inadequate. Use an extension cord with an adequate conductor cross section. Also, ensure that the control switch is fully pressed.
Explains the meaning of danger, warning, and caution symbols used in the manual for user safety.
Provides fundamental safety warnings for operating power tools, emphasizing reading instructions and general precautions.
Covers safety for work area, electrical, personal aspects, and power tool use and care.
Details additional safety measures for tool use, electrical, work area, and personal protective equipment (PPE).
Focuses on maintaining a safe work area and the importance of wearing appropriate personal protective equipment.
Details on adjusting the depth gauge, fitting, removing, and fitting the chuck.
Lists common faults, their possible causes, and recommended remedies for the power tool.
General| Input power | 710 W |
|---|---|
| Power source | AC |
| Carrying case | Yes |
| Chuck type | SDS Plus |
| Product color | Black, Red |
| Impact rate | 4980 bpm |
| Rated speed (max) | 1050 RPM |
| Impact energy (max) | 1.8 J |
| Sound level uncertainty | 89 dB |
| Vibration level (hammer drilling) | 11 m/s² |
| Drilling diameter in concrete (max) | - mm |
Weight and Dimensions| Weight | 2900 g |
|---|
To Next Page
