2.10 Using a generator or transformer
This power tool may be powered by a generator or transformer which fulfills the following conditions: The
unit must provide a power output in watts of at least twice the value printed on the type identification plate
on the power tool. The operating voltage must remain within +5% and -15% of the rated voltage at all times,
frequency must be in the 50 – 60 Hz range and never above 65 Hz, and the unit must be equipped with
automatic voltage regulation and starting boost.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching
other power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in
damage to the power tool.
3. Insert tools, accessories
Chuck TE‑C Click
Hammer drill bits Ø 4…24 mm
Lightweight percussion core bits Ø 25…68 mm
Multipurpose hole saws Ø 25…68 mm, hexagonal
Anchor-setting tools
C-type connection end
Quick-release chuck for wood and metal drill bits
For smooth or hex. shank
Key-type chuck For smooth or hex. shank
Wood drill bits Ø 5…20 mm
Metal drill bits Ø 5…13 mm
Metal drill bits / stepped drill bits Ø 5…22 mm
Dust removal attachment
TE DRS-M
Angular chuck
C-type connection end
Angular chuck
TE‑AC1
Keyless chuck
Bit holder
4. Technical data
Right of technical changes reserved.
NOTE
The power tool is available in various voltage ratings. Please refer to the power tool’s type identification plate
for details of its rated voltage and rated input power.
Rated
voltage
100 V 110 V 120 V 127 V 220 V 230 V 240 V
Rated
power
input
670 W 710 W 710 W 710 W 710 W 710 W 710 W
Rated cur-
rent input
7.2 A 6.9 A 6.3 A 6.0 A 3.4 A 3.3 A 3.2 A
Rated fre-
quency
50/60 Hz 50/60 Hz 60 Hz 60 Hz 50/60 Hz 50/60 Hz 50/60 Hz
en
4
To Next Page
