Power tool TE 7
Weight in accordance with EPTA procedure 01/2003 2.9 kg
Dimensions (L x W x H) 320 mm x 75 mm x 215 mm
Speed under no load
0…1,050/min
Hammer drilling speed 860/min
Single impact energy in accordance with EPTA
procedure 05/2009
1.8 J
NOTE
The vibration emission level given in this information sheet has been measured in accordance with a
standardised test given in EN 60745 and may be used to compare one tool with another. It may be used for a
preliminary assessment of exposure. The declared vibration emission level represents the main applications of
the tool. However if the tool is used for different applications, with different accessories or poorly maintained,
the vibration emission may differ. This may significantly increase the exposure level over the total working
period. An estimation of the level of exposure to vibration should also take into account the times when the
tool is switched off or when it is running but not actually doing the job. This may significantly reduce the
exposure level over the total working period. Identify additional safety measures to protect the operator from
the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of
work patterns.
Noise and vibration information (measured in accordance with EN 60745‑2‑6):
Typical A-weighted sound power level 100 dB (A)
Typical A-weighted emission sound pressure level 89 dB (A)
Uncertainty for the given sound level
3 dB (A)
Triaxial vibration values (vibration vector sum)
Drilling in metal, a
h, HD
4.5 m/s²
Hammer drilling in concrete, a
h, HD
11 m/s²
Uncertainty (K) 1.5 m/s²
Other information about the power tool
Chuck TE‑C Click
Protection class as per EN Protection class II (double insulated)
5. Safety instructions
NOTE
The safety rules in section 5.1 contain all general
safety rules for power tools which, in accordance
with the applicable standards, require to be listed in
the operating instructions. Accordingly, some of the
rules listed may not be relevant to this tool.
5.1 General Power Tool Safety Warnings
a)
WARNING
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions
may result in electric shock, fire and/or serious
injury. Save all warnings and instructions for
future reference. The term “power tool” in the
warnings refers to your mains-operated (corded)
power tool or battery-operated (cordless) power
tool.
5.1.1 Work area safety
a) Keep work area clean and well lit. Cluttered or
dark areas invite accidents.
b) Do not operate power tools in explosive atmo-
spheres, such as in the presence of flammable
en
5
To Next Page
