What to do if my Hilti Rotary Hammer gets very hot?
If your Hilti combihammer or the battery gets very hot: * Immediately switch off the product. * Remove the battery and keep it under observation. * Allow it to cool down. * Contact Hilti service.
How to release insert tool from Hilti Drill chuck?
If you can't release the insert tool from the chuck of your Hilti Drill, make sure the chuck is pulled back as far as it will go, and then remove the accessory tool. Also, check if the side handle is fitted correctly; disengage it and refit it so that the clamping band and side handle engage in the recess.
What to do if my Hilti Drill switches off automatically?
If your Hilti Drill switches off automatically, it's likely the overload protection system is active. To resolve this, release the control switch, allow the product to cool down, then press the control switch again. Also, reduce the load on the tool to prevent this from reoccurring.
What to do if the battery does not engage with an audible 'double click' on my Hilti TE 60-A36 Rotary Hammer?
If the battery does not engage with an audible 'double click' on your Hilti Rotary Hammer, the retaining lugs on the battery may be dirty. Clean the retaining lugs and refit the battery.
What to do if my Hilti TE 60-A36 product switches off automatically?
If your Hilti Rotary Hammer switches off automatically, the overload protection system may be active. To resolve this, release the control switch, allow the product to cool down, then press the control switch again. Also, reduce the load on the tool.
Why does my Hilti Rotary Hammer drill bit not rotate?
If the drill bit on your Hilti Rotary Hammer does not rotate, the function selector switch may not be engaged or is in the 'Chiseling' position or the 'Chisel positioning' position. With the motor at a standstill, set the function selector switch to the 'Hammer drilling' position.
Why my Hilti Drill does not start?
If your Hilti Drill does not start, it's possible that the electronic restart interlock has been activated due to an interruption in the electric supply. To fix this, switch the product off and then on again.
How to make Hilti Drill bit rotate?
If your Hilti Drill bit does not rotate, the function selector switch is not engaged or is in the "Chiseling" position or the "Chisel positioning" position. To fix this, with the motor at a standstill, set the function selector switch to the "Hammer drilling" position.
What does it mean if the ON/OFF indicator flashes on my Hilti TE 60-A36 Rotary Hammer?
If the ON/OFF indicator flashes on your Hilti Rotary Hammer, it could mean the product is momentarily overloaded. Release the control switch and then press it again. It could also indicate protection against overheating, so allow the product to cool down and clean the air vents.
What to do if Hilti Drill combihammer or battery gets very hot?
If the combihammer or battery of your Hilti Drill gets very hot, immediately switch off the product, remove the battery, keep it under observation and allow it to cool down. The cause may be an electrical fault or the product is overloaded. Also, consider whether you might have exceeded the application limit and select a product that is suitable for the intended purpose.
Provides essential safety guidelines for operating power tools.
Specific safety precautions for hammer operation and rotary drills.
Defines applications, limitations, and ATC feature.
Describes how to perform different tasks and use operating modes.
Lists common problems and their solutions.
General| Brand | Hilti |
|---|---|
| Model | TE 60-A36 |
| Category | Rotary Hammer |
| Language | English |
To Next Page
