Why is there no response from the LEDs on my Hilti Drill battery?
If there is no response from the LEDs on the battery of your Hilti Drill, ensure the battery is fully inserted until it engages with a double click. If that doesn't solve the issue, the battery may be discharged (change the battery and charge the empty one) or too hot/cold (bring the battery to the recommended working temperature).
What to do if my Hilti Rotary Hammer gets very hot?
If your Hilti combihammer or the battery gets very hot: * Immediately switch off the product. * Remove the battery and keep it under observation. * Allow it to cool down. * Contact Hilti service.
What to do if Hilti Drill combihammer or battery gets very hot?
If the combihammer or battery of your Hilti Drill gets very hot, immediately switch off the product, remove the battery, keep it under observation and allow it to cool down. The cause may be an electrical fault or the product is overloaded. Also, consider whether you might have exceeded the application limit and select a product that is suitable for the intended purpose.
Why is my Hilti Rotary Hammer not developing full power?
Your Hilti Rotary Hammer might not be developing full power because the control switch is not fully pressed. Ensure you press the control switch as far as it will go. Alternatively, the half-power button may be engaged; press the 'half-power' button to disengage it.
What to do if my Hilti Rotary Hammer drill bit jams and the product switches off?
If your Hilti Rotary Hammer switches off when the drill bit jams, the electronic safety shut-down has likely tripped to prevent further jamming. Release the drill bit to resolve this issue.
Why does my Hilti Rotary Hammer drill bit not rotate?
If the drill bit on your Hilti Rotary Hammer does not rotate, the function selector switch may not be engaged or is in the 'Chiseling' position or the 'Chisel positioning' position. With the motor at a standstill, set the function selector switch to the 'Hammer drilling' position.
What to do if the battery does not engage with an audible 'double click' on my Hilti TE 60-A36 Rotary Hammer?
If the battery does not engage with an audible 'double click' on your Hilti Rotary Hammer, the retaining lugs on the battery may be dirty. Clean the retaining lugs and refit the battery.
How to fix a Hilti Drill that does not develop full power?
If your Hilti Drill does not develop full power, ensure that the control switch is fully pressed. If it still lacks power, check if the half-power button is engaged and, if so, disengage it by pressing the 'half-power' button.
Why are 4 LEDs flashing on my Hilti Drill battery?
If 4 LEDs on the battery of your Hilti Drill flash, it could be due to a momentary overload or overheating protection. Try releasing the control switch and then pressing it again. If that doesn't work, allow the product to cool down and clean the air vents.
What to do if my Hilti Drill switches off automatically?
If your Hilti Drill switches off automatically, it's likely the overload protection system is active. To resolve this, release the control switch, allow the product to cool down, then press the control switch again. Also, reduce the load on the tool to prevent this from reoccurring.
General| Brand | Hilti |
|---|---|
| Model | TE 60-A36 |
| Category | Rotary Hammer |
| Language | English |
Provides essential safety guidelines for operating power tools.
Specific safety precautions for hammer operation and rotary drills.
Defines applications, limitations, and ATC feature.
Describes how to perform different tasks and use operating modes.
Lists common problems and their solutions.
To Next Page
