What to do if the drill bit cannot be released from Hilti Drill?
If the drill bit cannot be released from your Hilti Drill, ensure that you pull the tool lock back as far as it will go and then remove the tool.
Why doesn't my Hilti Drill achieve full power?
If your Hilti Drill is not achieving full power, first ensure that the control switch is fully pressed. If the issue persists, check that the function selector switch isn't set to “Light hammering action”; if it is, set it to the “Hammer drilling” position. Finally, verify that the extension cord has an adequate conductor cross section.
What to do if Hilti Drill bit cannot be released?
If you're having trouble releasing the drill bit from your Hilti Drill, make sure that the chuck is pulled back as far as it will go. Then, try removing the tool.
How to troubleshoot no hammering action on a Hilti Drill?
If your Hilti Drill has no hammering action, it may be too cold. Try bringing the tip of the drill bit into contact with the working surface, switch the rotary hammer on and allow it to run. Repeat if necessary, until the hammering mechanism begins to operate. Also, make sure that the function selector switch is set to the “Hammer drilling” position, and not “Rotary drilling only”.
What to do if Hilti Drill doesn't start?
If your Hilti Drill isn't starting, the issue might be with the electric supply. Try plugging in another electric tool or appliance to check if the outlet is working.
Why Hilti Drill doesn't achieve full power?
If your Hilti drill isn't reaching full power, consider these possibilities: 1. Ensure the control switch is fully pressed down. 2. Verify that the function selector switch is set to the “Hammer drilling” position and not “Light hammering action”. 3. Check that you're using an extension cord with an adequate conductor cross section.
What to do if Hilti Drill bit makes no progress?
If the drill bit on your Hilti drill isn't making any progress, check to see if the power tool has been set to reverse rotation. If it is, set the power tool to forward rotation.
How to fix no hammering action on Hilti Drill?
If your Hilti Drill has no hammering action, here are a couple of things to check: * First, the power tool might be too cold. Bring the tip of the drill bit into contact with the working surface, switch the rotary hammer on and allow it to run. If necessary, repeat the procedure until the hammering mechanism begins to operate. * Second, make sure the function selector switch is set to the “Hammer drilling” position, not “Rotary drilling only”.
How to troubleshoot a Hilti Rotary Hammer that doesn't start?
If your Hilti Rotary Hammer doesn't start, the issue could be an interruption in the electric supply. To check this, plug in another electric tool or appliance to the same outlet to see if it works. Alternatively, the carbon brushes may be worn out, so have the tool inspected by a trained electrical specialist and replace the carbon brushes if needed.
Why does my Hilti Rotary Hammer drill bit make no progress?
If your Hilti Rotary Hammer drill bit makes no progress, it might be set to reverse rotation. Ensure that the power tool is set to forward rotation to resolve this.
General safety advice for operating power tools.
Safety guidelines concerning electrical connections and usage.
Safety measures for the user's personal well-being.
Presents noise and vibration data according to EN 60745 standard.
Lists common problems and their solutions for the power tool.
General| Impact energy (max) | 1.8 J |
|---|---|
| Sound pressure level | 91 dB |
| Vibration level (hammer drilling) | 13.5 m/s² |
| Drilling diameter in concrete (max) | 12 mm |
| Reverse | Yes |
| Power source | AC |
Weight and Dimensions| Depth | 360 mm |
|---|---|
| Width | 89 mm |
| Height | 203 mm |
| Weight | 2900 g |
To Next Page
