How to release an insert tool stuck in a Hilti Drill chuck?
If the insert tool cannot be released from the chuck of your Hilti Drill, make sure that the chuck is pulled back fully and remove the accessory tool. Also, check if the side handle is fitted correctly, disengage it and refit it so that the clamping band and side handle engage in the recess.
Why is there no response from the LEDs on my Hilti Drill battery?
If there is no response from the LEDs on the battery of your Hilti Drill, ensure the battery is fully inserted until it engages with a double click. If that doesn't solve the issue, the battery may be discharged (change the battery and charge the empty one) or too hot/cold (bring the battery to the recommended working temperature).
Why is 1 LED flashing on my Hilti Drill battery?
If 1 LED on the battery of your Hilti Drill flashes, it indicates that the battery is either discharged (change the battery and charge the empty battery) or too hot/cold (bring the battery to the recommended working temperature).
Why does my Hilti Drill battery run down quickly?
If your Hilti Drill battery runs down more quickly than usual, it's likely that the battery condition is not optimal. Replace the battery to resolve this issue.
What to do if my Hilti Drill does not start?
If your Hilti Drill does not start, the electronic restart interlock may be activated due to an interruption in the electric supply. To fix this, switch the product off and then on again.
What to do if Hilti Drill battery doesn't engage with a double click?
If the battery of your Hilti Drill does not engage with an audible 'double click', the retaining lugs on the battery are likely dirty. Clean the retaining lugs and refit the battery.
Why is my Hilti Drill getting so hot?
If the combihammer or the battery gets very hot, there are several possible causes. First, there may be an electrical fault, so switch off the product immediately, remove the battery, keep it under observation, and allow it to cool down. Contact Hilti service. Second, the product might be overloaded, exceeding its application limit, in which case you should select a product suitable for the intended purpose. Third, the battery may not be fully inserted; push it in until it engages with a double click. Finally, the battery might be discharged; change the battery and charge the empty one.
Why my Hilti Drill does not start?
If your Hilti Drill does not start, it's possible that the electronic restart interlock has been activated due to an interruption in the electric supply. To fix this, switch the product off and then on again.
How to make Hilti Drill bit rotate?
If your Hilti Drill bit does not rotate, the function selector switch is not engaged or is in the "Chiseling" position or the "Chisel positioning" position. To fix this, with the motor at a standstill, set the function selector switch to the "Hammer drilling" position.
General| Brand | Hilti |
|---|---|
| Model | TE 60-A36 |
| Category | Rotary Hammer |
| Language | English |
Provides essential safety guidelines for operating power tools.
Specific safety precautions for hammer operation and rotary drills.
Defines applications, limitations, and ATC feature.
Describes how to perform different tasks and use operating modes.
Lists common problems and their solutions.
To Next Page
