What to do if Hilti Drill combihammer or battery gets very hot?
If the combihammer or battery of your Hilti Drill gets very hot, immediately switch off the product, remove the battery, keep it under observation and allow it to cool down. The cause may be an electrical fault or the product is overloaded. Also, consider whether you might have exceeded the application limit and select a product that is suitable for the intended purpose.
How to fix a Hilti Drill when the drill bit does not rotate?
If your Hilti Drill bit does not rotate, ensure that the function selector switch is set correctly. With the motor at a standstill, set the function selector switch to the 'Hammer drilling' position. Avoid 'Chiseling' or 'Chisel positioning' positions.
Why is the drive spindle not rotating on my Hilti Drill?
If the drive spindle of your Hilti Drill does not rotate, it could be due to two reasons. First, the product's electronics may have exceeded their permissible operating temperature; allow the product to cool down. Second, the battery may be discharged; change the battery and charge the empty one.
What to do if Hilti Drill switches off if drill bit jams?
If your Hilti Drill switches off when the drill bit jams, it's because the electronic safety shut-down has been activated to prevent further jamming. Simply release the drill bit to resolve this.
Why is the ON/OFF indicator flashing on my Hilti Drill?
If the ON/OFF indicator on your Hilti Drill flashes, it indicates a momentary overload or overheating protection. To solve this, release the control switch and then press it again. Additionally, allow the product to cool down and clean the air vents.
How to fix a Hilti Drill that does not develop full power?
If your Hilti Drill does not develop full power, ensure that the control switch is fully pressed. If it still lacks power, check if the half-power button is engaged and, if so, disengage it by pressing the 'half-power' button.
Why are 4 LEDs flashing on my Hilti Drill battery?
If 4 LEDs on the battery of your Hilti Drill flash, it could be due to a momentary overload or overheating protection. Try releasing the control switch and then pressing it again. If that doesn't work, allow the product to cool down and clean the air vents.
What to do if my Hilti Drill switches off automatically?
If your Hilti Drill switches off automatically, it's likely the overload protection system is active. To resolve this, release the control switch, allow the product to cool down, then press the control switch again. Also, reduce the load on the tool to prevent this from reoccurring.
How to release insert tool from Hilti Drill chuck?
If you can't release the insert tool from the chuck of your Hilti Drill, make sure the chuck is pulled back as far as it will go, and then remove the accessory tool. Also, check if the side handle is fitted correctly; disengage it and refit it so that the clamping band and side handle engage in the recess.
General| Brand | Hilti |
|---|---|
| Model | TE 60-A36 |
| Category | Rotary Hammer |
| Language | English |
Provides essential safety guidelines for operating power tools.
Specific safety precautions for hammer operation and rotary drills.
Defines applications, limitations, and ATC feature.
Describes how to perform different tasks and use operating modes.
Lists common problems and their solutions.
To Next Page
