*2201899*
2201899 English 11
5.1.2 Fitting the side handle 3
CAUTION
Risk of injury Loss of control over the product.
▶ Check that the side handle is fitted correctly and tightened securely.
Check that the clamping band is engaged in the groove in the product.
CAUTION
Risk of injury. The depth gauge, if fitted but not used, might hinder the
operator.
▶ Remove the depth gauge from the product.
1. Release the side handle clamping band by turning the handle grip.
2. Slide the side handle clamping band over the chuck from the front and
into the recess provided.
3. Set the side handle to the desired position.
4. Tighten the side handle clamping band by turning the handle grip.
5.1.3 Fitting the depth gauge (optional) 4
1. Release the side handle clamping band by turning the handle grip.
2. Slide the depth gauge from the front into the 2 guide holes provided.
3. Secure the side handle by turning the knob until the clamping band is
tight.
5.1.4 Setting the power level
After the battery is inserted, the product is always set by default to full
power.
1. Press the "button for half power". The product runs at half power.
▶ The "half power indicator" lights up.
2. Press the "button for half power" again. The product runs at full power.
▶ The "half power indicator" goes out.
5.1.5 Inserting / removing the accessory tool 5
DANGER
Risk of fire! Risk of contact between the hot accessory tool and highly
inflammable materials.
▶ Do not lay the hot accessory tool down on highly inflammable materials.
CAUTION
Risk of injury by the accessory tool! The accessory tool might be hot or
have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
To Next Page
Loading...
