Why Hilti TE 3-M Rotary Hammer doesn't achieve full power?
If your Hilti Rotary Hammer isn't reaching its full power, the issue might be with the extension cord. Ensure you are using an extension cord that has an adequate conductor cross section to provide sufficient power to the tool.
What to do if my Hilti TE 3-M Rotary Hammer has no hammering action?
If your Hilti Rotary Hammer isn't hammering, there could be a couple of reasons: 1. **Tool is too cold:** Try bringing the tip of the drill bit into contact with the working surface, switch the rotary hammer on and allow it to run. If necessary, repeat the procedure until the hammering mechanism begins to operate. 2. **Function selector switch:** Check that the function selector switch is set to the “Hammer drilling” position and not “Rotary drilling only”.
How to fix a Hilti TE 3-M Rotary Hammer that doesn’t start?
If your Hilti Rotary Hammer isn’t starting, the problem might be due to an interruption in the electric supply. To check this, plug in another electric tool or appliance into the same outlet to see if it works.
General| Weight | 3.5 kg |
|---|---|
| Drilling diameter in concrete | 4 - 28 mm |
| Drilling diameter in wood | 3 - 30 mm |
| Hammer Drilling in Concrete | Yes |
| Drilling in Wood | Yes |
| Drilling in Metal | Yes |
| Forward/Reverse | Yes |
| Dust Removal Module Available | Yes |
| Voltage | 230 V |
| Tool Chuck Type | TE-C (SDS Plus) |
| No-load speed | 1100 rpm |
| Tool holder | TE-C (SDS Plus) |
| Working Mode | Hammer drilling |
To Next Page
