English 7
3.5 Motor protection system
The tool is equipped with a motor protection system. The system monitors
current input and motor temperature and thus prevents the tool from
overheating.
If the motor is overloaded through application of excessive working pressure,
the power tool’s performance drops noticeably or it may stall completely.
If the power tool stalls or slows significantly due to overloading, release the
pressure applied to the tool and then allow it to run under no load for approx.
30 seconds.
3.6 Items supplied
Rotary hammer, side handle, depth gauge, operating instructions.
Note
For safe, reliable operation, use only genuine Hilti spare parts and
accessories. Spare parts, accessories and consumables approved by
Hilti for use with this product can be found at your Hilti Center or at
www.hilti.com.
4 Technical data
Note
For details of the rated voltage, current, frequency and/or input power,
please refer to the power tool’s country-specific type identification plate.
When powered by a generator or transformer, the generator or transformer’s
power output must be at least twice the rated input power shown on the rating
plate of the power tool. The operating voltage of the transformer or generator
must always be within +5% and -15% of the rated voltage of the power tool.
Model
TE 30 TE 30AVR
Weight
9.0 lb
(4.1 kg)
9.3 lb
(4.2 kg)
Ø hammer drill bits
1/4 in … 1 1/8 in 1/4 in … 1 1/8 in
Ø hammer drill bits
6 mm … 28 mm 6 mm … 28 mm
Ø drill bits for wood
3/16 in … 1 in 3/16 in … 1 in
Ø drill bits for wood
3 mm … 25 mm 3 mm … 25 mm
Ø drill bits for metal
3/16 in … 1/2 in 3/16 in … 1/2 in
Ø drill bits for metal
3 mm … 13 mm 3 mm … 13 mm
Printed: 03.03.2017 | Doc-Nr: PUB / 5324643 / 000 / 01
To Next Page
Loading...
Need help?
General
