Hilti TE 6-A22 - Page 13

*2166350*
2166350 English 5
2.5 Battery use and care
▶ Observe the special regulations and instructions applicable to the transport, storage and use of Li-ion
batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over 80 °C.
▶ Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height
or show signs of damage. In this case, always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. In this case, place the product in a non-flammable
location, well away from flammable materials, where it can be kept under observation and allowed to
cool down. In this case, always contact your Hilti Service.
3 Description
3.1 Overview of the product 1
@
Dust shield
;
chuck
=
Insert tool unlocking device
%
Depth gauge
&
Function selector switch
(
Forward / reverse selector switch with safety
lock
)
Control switch
+
Grip
§
Battery release buttons
/
Charge status and fault display (Li-ion bat-
tery)
:
Battery
∙
Connection for the TE DRS-6-A(02) dust re-
moval module
$
Side handle
£
Light to illuminate the work area
3.2 Intended use
The product described is a cordless rotary hammer drill. It is designed for drilling in steel, wood and masonry,
for hammer-action drilling in concrete and masonry, and for driving and removing screws. The product can
also be used for light chiseling work on masonry and surface finishing on concrete.
▶ Use only Hilti lithiumion batteries of the B 22 series with this product.
▶ Use only the Hilti lithium-ion batteries from the B22 series for this product.
3.3 Lithiumion battery status display
The charge status of the Li-ion battery and malfunctions of the power tool are indicated by the display on
the Liion battery. The charge status of the Liion battery is displayed after pressing one of the two battery
release buttons.
Status Meaning
4 LEDs light up. Charge status: 75 % to 100 %