6 English 2166350
*2166350*
Status Meaning
3 LEDs light up. Charge status: 50 % to 75 %
2 LEDs light up. Charge status: 25 % to 50 %
1 LED lights up. Charge status: 10 % to 25 %
1 LED blinks. Charge status: < 10 %
Battery charge status cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch. If the battery display LEDs blink, please observe the instructions
given in the Troubleshooting section.
3.4 Items supplied
Rotary hammer, side handle, depth gauge, operating instructions.
You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.com.
4 Technical data
4.1 Rotary hammer
TE 6A22
Rated voltage
21.6 V
Weight in accordance with EPTA Procedure 01 including B22⁄8.0
battery
3.8 kg
Rated speed under no load
1,050 /min
Drilling diameter range in concrete/masonry (hammer drilling)
5 mm … 20 mm
Drilling diameter range in wood (solid)
3 mm … 20 mm
Drilling diameter range in metal (solid-head drill bit)
3 mm … 13 mm
4.2 Noise and vibration values in accordance with EN 60745
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure. The data given represents the main applications of the power tool.
However, if the power tool is used for different applications, with different accessory tools, or is poorly
maintained, the data can vary. This can significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the power tool is switched
off, or when it is running but not actually being used for a job. This can significantly reduce exposure over
the total working period. Identify additional safety measures to protect the operator from the effects of noise
and/or vibration, for example: maintaining the power tool and accessory tools, keeping the hands warm,
organization of work patterns.
Noise values
Sound (power) level (L
WA
)
100 dB(A)
Uncertainty for the sound power level (K
WA
)
3 dB(A)
Emission sound pressure level (L
pA
)
89 dB(A)
Uncertainty for the sound pressure level (K
pA
)
3 dB(A)
Vibration values
Hammer drilling in concrete (a
h, HD
)
13.4 m/s²
Drilling in metal (a
h, D
)
2.1 m/s²
Chiseling (a
h, CHeq
)
6.3 m/s²
Uncertainty (K)
1.5 m/s²
To Next Page
Loading...
