Hilti TE 6-A36 - Before Use; Battery Use and Care; Charging the Battery; Fitting the Battery

8 English 2100249
*2100249*
3. After fitting the accessory tool, grip it and pull it in order to check that it is securely engaged.
▶ The product is ready for use.
5.8 Removing the accessory tool
▶ Pull the chuck back as far as it will go and remove the accessory tool.
5.9 Overhead work 7
▶ Fit the DCD dust control ring for overhead work.
5.10 Chisel positioning 8
▶
Set the function switch to the position.
6 Types of work
6.1 Function selector switch 8
▶ Set the function selector switch to the desired working position.
▶ Do not operate the function selector switch while the motor is running. Risk of damage!
6.2 Forward/reverse 9
▶ Set the forward/reverse switch to the desired direction of rotation.
6.3 Drilling without hammer action
▶
Set the function selector switch to the position.
6.4 Drilling with hammer action
▶
Set the function selector switch to the position.
6.5 Chiseling
▶
Set the function switch to the position.
▶ For optimum motor cooling, select the forward direction, i.e. clockwise (direction of rotation for
drilling).
7 Care and maintenance
7.1 Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!