Table of Contents System Manual Compact Systems
Page 6 of 110 HI 800 141 E Rev. 2.02
7.7.4.2 Configuring Pulsed Outputs 79
7.7.4.3 Configuration Example with ELOP II Factory 80
7.7.5 Generating the Code for the Resource Configuration 81
7.7.6 Configuring the System ID and the Connection Parameters 81
7.7.7 Loading a Resource Configuration after a Reset 82
7.7.8 Loading a Resource Configuration from the PADT 82
7.7.9 Loading a Resource Configuration from the Flash Memory of the Communication
System 83
7.7.10 Deleting a Resource Configuration from the Flash Memory of the Communication
System 84
7.8 Configuring Communication with ELOP II Factory - up to CPU OS V7 84
7.8.1 Configuring the Ethernet Interfaces 84
7.8.2 System Signals of safeethernet Communication 87
7.8.3 Configuring the safeethernet Connection 89
7.8.4 Configuring the Signals for safeethernet Communication 90
7.9 Handling the User Program 91
7.9.1 Setting the Parameters and the Switches 91
7.9.2 Starting the Program from STOP/VALID CONFIGURATION 91
7.9.3 Restarting the Program after Errors 91
7.9.4 Stopping the Program 92
7.9.5 Program Test Mode 92
7.9.6 Online Test 92
8 Operation 93
8.1 Handling 93
8.2 Diagnosis 93
8.2.1 Light-Emitting Diode Indicators 93
8.2.2 Diagnostic History 93
8.2.3 Diagnosis in SILworX- CPU OS V7 and Higher 95
8.2.4 Diagnosis in ELOP II Factory - up to CPU OS V7 95
9 Maintenance 96
9.1 Interferences 96
9.2 Loading Operating Systems 96
9.2.1 Loading the Operating System with SILworX 96
9.2.2 Loading the Operating System with ELOP II Factory 97
9.2.3 Switching between ELOP II Factory and SILworX - not with F*03 97
9.2.3.1 Upgrading from ELOP II Factory to SILworX 97
9.2.3.2 Downgrading from SILworX to ELOP II Factory 98
9.3 Repair of Devices and Modules 98
10 Decommissioning 99
11 Transport 100
12 Disposal 101
Appendix 103
Glossary 103
Index of Figures 104
Declaration of Conformity 107
Index 108
To Next Page
Loading...
Need help?
General
