HIMA HIMatrix F35 - Configuring the User Program; Table 46: Resource Configuration Parameters - CPU os up to V7

7 Start-Up System Manual Compact Systems
Page 76 of 110 HI 800 141 E Rev. 2.02
Parameter
Range
Description
Default value
Off:
Load not allowed
Test Mode
Allowed
On/Off
Test mode
Off
On:
Test mode Allowed
Off:
Test mode not allowed
Changing the
variables in the
OLT allowed
On/Off
Changing variables in the online test
On
On:
Allowed
Off:
Not Allowed
Forcing Allowed
On/Off
On:
Forcing Allowed
Off
Off:
Forcing not allowed
Stop at Force
Timeout
On/Off
On:
STOP upon expiration of the force
time.
On
Off:
No STOP upon expiration of the force
time.
Max. Com.Time
Slice [ms]
2...5 000 ms
Time for performing the communication
tasks
10 ms
Table 46: Resource Configuration Parameters - CPU OS up to V7
Refer to the HIMatrix system safety manual (HI 800 023 E) for more details on how to configure
a resource for safety-related operation.
7.7.2 Configuring the User Program
General system signals and parameters
Signal
[Data type],
Unit, value
R/W
Description
System ID
high/low
[USINT]
R
CPU system ID (the first part of the SRS)
[not safe]
1)
OS major
version
OS major high
OS major low
[USINT]
R
Major version of CPU operation system (OS)
Example: OS V6.12, major version: 6
OS V6, valid if system ID  0
[not safe]
OS minor
version OS
minor high
OS minor low
[USINT]
R
Minor version of CPU operation system (OS)
Example: OS V6.12, minor version: 12
OS V6, valid if system ID  0
[not safe]
Configuration
signature
CRC byte 1
through 4
[USINT]
R
CRC of the configuration loaded, only valid in the states
RUN and STOP VALID CONFIGURATION.
OS V6, valid if system ID  0
[not safe]
Date/Time
[sec part] and
[ms part]
[USINT]
s
ms
R
Seconds since 1970, and ms
Changing automatically between Winter and Summer
time is not supported.
[not safe]
Remaining force
time
[DINT]
ms
R
Remaining time during Forcing;
0 ms if forcing is not active.
[not safe]
Fan state
2)
[BYTE]
0x00
0x01
R
Normal (fan ON)
Fan defective
[not safe]