Thus, the software needs to check against the channel
setting stored in the EEPROM long press the Hi/Lo/LOCK
switch lock function
Up/Down Key
At the normal mode, they act as Channel Up/Down key.
When it presses > 0.5 sec, the channels will change in a
quick way. It returns to normal mode when key press is
released.
LOC/DX
Short press to get conversion between local and distance
mode (DX allows normal receive sensitivity; and
“LOCAL” eliminates receiver noise, but degrades receiver
sensitivity meanwhile “LOCAL” icon display on LCD)
.
16/9 Key
At the normal mode, pressing the 16 / 9 Key (short press to
jump to priority CH16 at High Power and long press to
jump to priority CH9 at High Power) if the current channel
is not the priority channel.
After the channel is tuned to the priority channel, “P-CH”
or “P-2nd” icon is lit to indicate the priority CH16 or CH9
has been reached. UP/Down key functions normally.
Select second priority channel
Solution 1: Select the second priority channel by “16/9”
key: the second priority channel is set as channel 9 by
default. At the normal mode, long press “16/9” key,
“P-2nd” will be displayed as the second priority channel on
LCD, then long press “16/9” key again, “set P-2nd CH”
will be displayed on LCD and the displayed channel will
keep on flashing, then press “UP/Down” key to choose
your preferred channel as new second priority channel.
Finally, long press “16/9” key again to save and confirm it.
Solution 2: Select the second priority channel by
“CALL/Menu” key: long press “CALL/Menu” key to
select “VHF operation” option, and press to select the
“Priority 2nd Ch”, then press and select your preferred
channel by “Up/Down” key and confirm it.
CALL/MENU
Short press to enter “DSC Menu”, long press to enter
“Main Menu” (detailed operation please see 3. Main Menu
Operation on Screen)
Back Light
Short press to switch the Back Light On and Off. Short
Press ‘Backlight’ key the light will keep turning on. Press it
again, it’ll turn off. If the backlight setting is off, press any
key will turn on the backlight except the PTT key. The
backlight should be remaining for 5 seconds if no any keys
pressed. The time out will be reset if any key pressed
within the time frame.
CH/*/WX
(WX Channel: Only available for USA, Canada)
A short press of “CH/*/WX” key will trigger Private
channel if there are private channels in memory. Pressing
the “Up/Down” key will change private channel selection.
A long press of “CH/*/WX” key will enter WX mode in
USA or CAN Band. Pressing “Up/Down” key will change
WX channel. The “WX” icon will be displayed on the
screen.
Weather Alert Operation: (USA and CAN Band only)
When in the Weather mode, a long press the “CH/*/WX”
key will switch on the Weather Alert function. Toggling the
Weather Alert function ON/OFF. The icon “WAT” will be
displayed accordingly, When Weather Alert function is
enabled, every 4 seconds the last used weather channel will
be checked for weather alert tone when the radio is tuned
to working channel. With Weather Alert Function enabled,
once the alert tone is detected, the “Weather Alarm” will be
display and alarm sounds. After silencing the weather
alarm, the radio will automatically tune to the current WX
channel where the weather alert has been detected. The
alert will be detected in the modes of Dual/Tri-watch, Scan
operation etc.
6.Other Features and Solutions
Special function keys
if you press and hold the"DISTRESS"Key then power on,
To Next Page
Loading...