Hioki 3283 - Preparations; Measurement Procedure; Chapter 2 Measurement Procedure

7
Chapter 2 Measurement Procedure
Fresh battery
Battery capacity 50%
Battery capacity 0
Beep tone sounds 3 time
s
Chapter 2
Measurement
Procedure
2.1 Preparations
1. Remove the rear cover and insert the battery.
(Refer to "Chapter3 Battery Replacement".)
2. Press the
POWER
key to turn the unit on.
Verify that all segments of the display light
upbriefly.Thenthemodelnameisshown,
and the bar graph indicates the battery
condition.
3. The AC current measurement mode is
activated.
【Low battery voltage detection function】
After the
mark lights and battery voltage
drops below a certain level, the power goes off
automatically. When this occurs, bAtt and Lo
are displayed.
When power goes off after display of these
marks, replace the exhausted battery with a
new one.