Hioki 3283 - Aps 18

18
Chapter 2 Measurement Procedure
NOTE
2.6 Auto Power-Off Function APS
･ Momentary power loss and power surges
cannot be detected.
･ When the unit is turned off, accumulated
data are lost.
･ The maximum recording duration depends on
the remaining battery capacity.
･ The lowest possible frequency that can be
displayedis30Hz.
･ If the measurement object was clamped after
activating the recording function, the
minimum value is always zero. To prevent
this, clamp the conductor first and the press
the
MAX/MIN
keytoactivatetherecording
function.
･ If the clamp sensor is removed from the
measurement object while the recording
function is active, the minimum value will
become zero. To prevent this, press the
HOLD
key before removing the clamp sensor.
･ To turn off the recording function, press
A
〜
〜〜
〜
key. The maximum value, minimum
value, and average value are cleared.
When
APS
is displayed, the auto power-off
function is active.
Ifnokeyispressedforabout10minutes,the
unit turns itself off automatically.
Immediately before turning off, the
APS
indication flashes and a beep tone is heard for
about 30 seconds.