Why does the MEASURE key enable the lock function after releasing it in Hioki IR4053?
If, in the 500 V, 1000 V, or PV range, turning on the MEASURE key enables the lock function that has been released on your Hioki Test Equipment, replace the batteries with new alkaline batteries and release the lock function again.
What to do if the MEASURE key is not working for the lead with a switch on my Hioki IR4053 Test Equipment?
If the MEASURE key is not working for the lead with a switch on your Hioki Test Equipment, ensure that you fully insert the plug to the limit without any gaps.
How to fix Hioki IR4053 when unable to perform measurement in 500 V, 1000 V or PV range?
If you are unable to perform measurements in the 500 V, 1000 V, or PV range on your Hioki Test Equipment, release the lock function.
What should I do if the protective fuse has tripped in my Hioki IR4053 Test Equipment?
If the protective fuse in your Hioki Test Equipment has tripped, replace it with the indicated fuse.
What to do if my Hioki IR4053 shows the maximum display value?
If the measured value on your Hioki Test Equipment is shown as the maximum display value, check the continuity of the test lead with a tester. Also, check the connection between the test leads and the instrument, and the connection of the tips of the test leads.
Why do the batteries in my Hioki IR4053 run out so quickly?
If the batteries in your Hioki Test Equipment run out immediately, replace them with alkaline batteries.
How to fix Hioki IR4053 when the power is not turning on?
If your Hioki Test Equipment is not turning on, replace the batteries with new ones and ensure they are installed in the correct orientation.
General| Measurement Voltage | 50V, 125V, 250V, 500V, 1000V |
|---|---|
| Category | Insulation Tester |
| Insulation Resistance Range (1000V) | 0.001 MΩ to 4000 MΩ |
| AC Voltage Measurement | 0 to 600 V AC |
| Display | LCD |
| Power Supply | AA alkaline battery (LR6) × 4 |
| Dimensions | 159 mm × 177 mm × 53 mm |
| Weight | 680 g |
To Next Page
