36
Measurement Process
1.4 Measurement Process
This section describes how to make measurements using the instrument.
1
Prepare to use the instrument.
See “Making Connections (Preparing for Measurement)” (p. 37).
• If using one or more plug-in modules, install them in the instrument.
• Connect either the AC Adapter or a charged Battery Pack.
2
Connection the cables.
See “2.5 Connecting the Cables” (p. 49).
• Connect sensors, such as thermocouples and Humidity Sensors, to the terminal blocks of the
measurement modules.
3
Turn on the instrument.
See “2.6 Turning the Instrument On and O” (p. 66).
• Press the power key to turn on the instrument.
4
Congure the Input channels.
• Set the recording interval (sampling interval) and recording time.
See “1.3 Setting Measurement Conditions” in the Instruction Manual.
• Set the input type, such as voltage and temperature, and the range.
See “1.4 Conguring Input Channels” in the Instruction Manual.
5
Stop/start measurement.
See “Starting and stopping measurement” (p. 79).
Press the START key to start measurement.
Press the STOP key to stop measurement.
6
Observe waveform data.
• You can scroll the waveform display in the time (horizontal) axis to observe.
See “1.12 Observing Waveforms” in the Instruction Manual.
• You can use the A/B cursors to read values from waveforms.
See “1.13 Using the A/B Cursors” in the Instruction Manual.
7
Save the data.
• You can save measured waveforms and setting conditions onto storage media.
See “Saving data” (p. 81).
• The instrument can load saved waveforms and settings data.
See “Loading data” (p. 81).
To Next Page
Loading...
