Introduction
12
1.3
Command Line Interface
RM CLI EAGLE 20
Release
4.3
09/08
1.3 Command Line Interface
The Command Line Interface enables you to use all the functions of the de-
vice via a local or remote connection. This enables you to securely administer
the firewall via V.24 or via the Secure Shell (SSH) protocol. You can also de-
fine rules to secure the access and the administration.
The Command Line Interface provides IT specialists with a familiar environ-
ment for configuring IT devices. As an experienced user or administrator, you
have knowledge about the basics and about using secure shell (SSH)
connections.
The “Command Line Interface” reference manual gives you step-by-step in-
formation on using the Command Line Interface (CLI) and its commands.
The commands in the Command Line Interface of the EAGLE 20 Firewall can
be divided into the following areas:
X Authentication
X Delete
X Copy
X Deny Service
X Device Status
X Interface
X Logging
X NAT (Network Address Translation)
X Network
X Packet Filter
X Profiles
X Signal Contact
X SNMP Trap (Simple Network Management Protocol)
X SNTP (Simple Network Time Protocol)
X Users
X Display
To Next Page
Loading...
