Hirschmann EAGLE 20 - Structure of a Command

Using the CLI
28
3.2 Executing commands
RM CLI EAGLE 20
Release 4.3 09/08
The command tree branches for the required parameters until the required
parameters have reached the end point.
With optional parameters, the command tree branches until the required pa-
rameters and the optional parameters have reached the end point.
Note: The command “show system commandtree” lists the entire command
tree for you.
3.2.3 Structure of a command
This section describes the syntax, conventions and terminology, and uses
examples to represent them.
 Format of commands
Most of the commands are enhanced through parameters.
If the command parameter is missing, CLI informs you that the syntax of
the command is incorrect.
The commands and parameters are displayed in the Courier font in
this manual, and they must be used as they are shown in the manual.
 Parameters
You must adhere to the sequence of the parameters shown.
Parameters can be required values, optional values, selections, or a com-
bination of these things. You recognize this from the way they are repre-
sented, as follows:
X <parameter>
Pointed brackets indicate a required parameter.