Installation EAGLE One
Release
03
07/2014
9
Warning! This is a class A device. This device can cause interference in
living areas, and in this case the operator may be required to take
appropriate measures.
Note: The assembly guidelines provided in these instructions must be
strictly adhered to in order to observe the EMC threshold values.
Relevant for use in North America
Use this device solely in Class 2 Circuits.
Relevant for USE in Hazardous Locations Class I Division 2,
Groups A, B, C, D
The relay connections and the USB connetions are to be installed and
used within their Entity Parameters as per Control Drawing
000174247DNR – details see the next two pages.
To Next Page
Loading...
