Programming
© 2008 HIRSCHMANN Automation and Control GmbH · Branch Office Ettlingen · eMail: info.ecs@hirschmann.de · www.hirschmann-usa.com 16
50 650 19 0201e_Rev C (LinkBelt278).doc / 2008-08-18 / Rev. C / rk
• Confirmation screens:
In this menu screens, the operator is prompted to confirm the previous made entries if crane configu-
ration has not been modified since last turning off the system.
Check the displayed values before confirming them!
< OK, if all entries are correct
< DELETE entries, renew setup
< Quick change hoist selection
If "OK" was selected the next menu appears:
< OK, if all entries are correct
< Renew pickpoint and reeving
selection
The procedure is completed after this confirmation, and the crane menu is displayed.
To Next Page
Loading...