Programming
© 2008 HIRSCHMANN Automation and Control GmbH · Branch Office Ettlingen · eMail: info.ecs@hirschmann.de · www.hirschmann-usa.com 17
50 650 19 0201e_Rev C (LinkBelt278).doc / 2008-08-18 / Rev. C / rk
4.1 Interactive operating mode setup
It is necessary to setup the system by entering the respective mode of operation every time the crane
structure is modified.
The system will temporarily interrupt the movements of the crane during the programming procedure.
The correct setting is of utmost importance for the proper functioning of the system
and the crane. Therefore, only operators who are thoroughly familiar with the crane
and the operation of the system should execute the setting of the system
according to the operating configuration of the crane.
The LMI programming procedure consists of the following steps (interactive operation):
• setting the boom type configuration
• specify jib / selecting the pick point
• setting the outrigger configuration
• setting the counterweight configuration
• setting the hoist
• setting the reevings
• confirmation of the programming procedure
For easy operation, the computer guides the operator through the procedure step by step.
Calling up the function:
Select the soft function key
and actuate the rotary wheel button (from the LMI screen)
To Next Page
Loading...