Troubleshooting
© 2008 HIRSCHMANN Automation and Control GmbH · Branch Office Ettlingen · eMail: info.ecs@hirschmann.de · www.hirschmann-usa.com 45
50 650 19 0201e_Rev C (LinkBelt278).doc / 2008-08-18 / Rev. C / rk
7. TROUBLESHOOTING
7.1 General
In the event of a malfunction or an operating error recognized by the system,
codes will be displayed in the status field of the Data display (1) which specify
the reason for the malfunction:
Error in the LMI system:
Error in the control system:
or
The error codes listed in the following Malfunction Table will identify various
faults which can occur with this system. Malfunctions in the LMI System which
were caused by exceeding the prescribed ranges or by operating errors on the
part of the crane operator can normally be corrected by the crane operator him-
self. Errors in the microprocessor system may only be corrected by factory-
trained Customer Service personnel.
Contact Hirschmann Customer Service or local dealer if this occurs.
Internet Support:
www.hirschmann-usa.com
> ELECTRONIC CONTROL SYSTEMS > Service &
Support
To Next Page
Loading...