Programming
© 2008 HIRSCHMANN Automation and Control GmbH · Branch Office Ettlingen · eMail: info.ecs@hirschmann.de · www.hirschmann-usa.com 23
50 650 19 0201e_Rev C (LinkBelt278).doc / 2008-08-18 / Rev. C / rk
4.2 Quick hoist in use selection
If, during the crane operation, the crane is switched over from front to rear hoist, the LMI system has to be ad-
justed to this modification. This modification can be entered without having to go through the whole LMI setup
procedure again:
Calling up the function:
By selecting the the soft function key
and actuating the rotary wheel button (from the LMI
screen)
Start of configuration setup menu:
< Start operation mode setup
DELETE entries, renew setup
< Quick change hoist
OK, if all entries are correct
To Next Page
Loading...