Rapid Spanning Tree
110
6.7
Combination of RSTP and MRP
Redundanz L2P
Release
5.0
04/09
Activate RSTP at the ports here using S1 as an example.
Configure globally here using S1 as an example:
– the RSTP priority
– global operation
– the MRP compatibility mode
Configure all the participating devices in accordance with the table.
Connect the redundant RSTP connection.
enable Switch to the Privileged EXEC mode.
configure Switch to the Configuration mode.
interface 1/1 Switch to the Interface Configuration mode of
interface 1/1.
spanning-tree port mode Activate RSTP at port.
exit Switch to the Configuration mode.
interface 1/2 Switch to the interface configuration mode for
port 1.2.
spanning-tree port mode Activate RSTP at port.
exit Switch to the Configuration mode.
interface 1/3 Switch to the interface configuration mode for
port 1.3.
spanning-tree port mode Activate RSTP at port.
exit Switch to the Configuration mode.
spanning-tree mst priority 0
4096
Set the RSTP priority to the value 4096.
spanning-tree Activate RSTP operation globally.
spanning-tree stp-mrp-mode Activate MRP compatibility.
To Next Page
Loading...
Need help?
General
