EasyManuals Logo

Hirschmann MACH 100 Programming Manual

Hirschmann MACH 100
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #62 background imageLoading...
Page #62 background image
Ring/Network coupling
62
5.2
Preparing a Ring/Network coupling
Redundanz L2P
Release
5.0
04/09
Figure 25: Selecting the port and enabling/disabling operation
Note: The following settings are required for the coupling ports (you
select the Basic Settings:Port Configuration dialog):
Port: on
Automatic configuration (autonegotiation):
on for twisted-pair connections
Manual configuration: 100 Mbit/s FDX
for glass fiber connections
Note: If VLANS are configured, note the VLAN configuration of the
coupling and partner coupling ports.
In the Network/Ring Coupling configuration, select for the coupling and
partner coupling ports
VLAN ID 1 and “Ingress Filtering” disabled in the port table and
VLAN membership U in the static VLAN table.
Redundancy mode
In the “Redundancy Mode” frame, select (see fig. 26)
“Redundant Ring/Network Coupling” or
“Extended Redundancy”.

Other manuals for Hirschmann MACH 100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hirschmann MACH 100 and is the answer not in the manual?

Hirschmann MACH 100 Specifications

General IconGeneral
BrandHirschmann
ModelMACH 100
CategorySwitch
LanguageEnglish

Related product manuals