Hirschmann PAT DS 85/0002 - Extensions - Function E

Calibration Manual DS85
031-300-190-169 REVISION B 01/06/04 190169_B
6
2.4.2 Extensions - Function E
If the hook block needs to be adjusted use the following procedure:
NOTE: Adjustment of radius display empty and empty tackle display is possible for any boom length
1) Use the “E” function to correct from high to low angle. Do not change the radius during the
“E” function.
2) Proceed with cutoff test.
User Inputs Hand Terminal Display Remarks
PRESS “E“ enter measured
radius or CR:
PRESS "ENTER" enter tackle or CR
tackle: XX:
PRESS "ENTER" A=MB down, CR=End,
B=adj. on the fly
dynamic adjustment
Ö
A
: The empty tackle weight is
corrected dynamically for all
correction positions of the present
length.
PRESS "A" Press "E“ prior to stop Luff down boom, the dynamic
adjustment will be completed
automatically upon reaching the
last correction position. It may
happen that the last angle is not
attainable. In such cases do not
exceed load chart.
Enter measured radius or CR Do not adjust the radius
PRESS "ENTER" Func. "E" finished
Press "K"
PRESS "K"