Hisense 32A4K - Page 8

6
Insert the batteries
1. Take off the back cover to open the battery compartment of the remote control.
2.InserttwoAAorAAA(1.5Vcc)sizebatteries.Makesuretomatchthe(+)and(-)
endsofthebatterieswiththe(+)and(-)endsindicatedinthebatterycompartment.
3. Restore the battery compartment cover.
Important information about the remote and batteries
• Discard batteries in a designated disposal area. Do not throw them into a fire.
• Remove old batteries immediately to prevent them from leaking into the battery
compartment.
• If you do not intend to use the remote control for a long time, then remove the
batteries.
• Battery chemicals can cause a rash. If the batteries leak, clean the battery
compartment with a cloth. If chemicals touch your skin then wash it immediately.
• Do not mix old and new batteries.
• Donotmixalkaline,standard(carbon-zinc)orrechargeable(NiCd,NiMH,etc.)
batteries.
• Do not continue using the remote if it gets warm or hot.
• Call our Support Center immediately on the support website.
Remote control range information
•
Theremotecontrolcanworkatadistanceofupto26feet(792.5cm)infrontoftheTVset.
• It can work at a 30 degree horizontal or vertical angle.
Pairing the remote control
1. Pair the remote to the TV after you power it on. Keep the remote control within 10
feet(304.8cm)fromtheTV.
2. Press the
Home
button on the remote control, select
icon to enter the Settings
menu to select Remotes & Accessories.
3. Press and hold the
and button at least 3 seconds to start pairing. Select the
remote name, and press the [OK] button to start pairing.
4. Iftheremotepairssuccessfully,aconrmationwilldisplayonthescreen.Ifitdoesnot
pair successfully, an unsuccessful message will display. Repeat the previous steps.
NOTE:
• If an unknown error occurs with the remote, it could have been caused by
interference. Try to remove what's causing the interference and pair the remote
again.
• If an unknown error occurs with the remote control while the battery power is
normal, you can take out the batteries and press any key for 1~2 seconds, and
insert them back. The remote control can work normally.
• The remote cannot be paired to the TV while the TV is in the standby mode.