High temperature alarm
If the temperature inside the appliance is too high, then an acoustic alarm
will be activated (intermittent tone). HI will flash on the C1 display unit,
and the symbol for the part of the appliance where the temperature is
too high (B1 or B2) will be lit.
• Every time the appliance is switched on with the A key, there is a
24-hour delay in high temperature alarm operation. If the appliance
does not reach the sufficiently low temperature in this period, the
alarm will be activated.
Switching off the alarm:
• Acknowledge and turn off the acoustic alarm by pressing any key. Current temperature in the
compartment where the temperature is too high will start to flash on the C1 display unit. If you do
not acknowledge and switch off the acoustic alarm, then it will be activated every hour for
approximately 15 minutes.
• The next time you press the C key, the set temperature display for the compartment with excessive
temperature will start to flash. At the same time, the symbol for the compartment in which the
temperature is too high will also be lit up (B1 or B2).
• When the temperature drops to below the alarm value, then the temperature display will stop
flashing and it will be lit continuously. Refrigerator compartment temperature will be displayed
and the B2 symbol will light up.
Open door alarm
If the refrigerator or any of the freezer compartment doors are open for too long, an acoustic alarm
(repetitive beep) will be activated. If the alarm is not deactivated, it will be sounded once every hour
until you turn it off.
The appliance will continue to operate as if the door (or the compartment) was closed.
31
To Next Page
Loading...
Need help?
General
