Reversing the door opening direction
The direction in which the appliance door opens can be reversed.
Note: Disconnect the appliance from the power mains before reversing the door opening direction.
Tools required:
Socket wrench No. 8,
Cross-point screwdriver
Flat screwdriver
Spanner No. 8
Note:
• If the appliance has to be tilted to allow access to parts on the bottom, ask another person for
assistance or gently place the appliance on some soft padding to prevent damaging it. To reverse
the opening direction, proceed as follows.
1. Place the appliance in an upright position. Open the door and
remove the door racks (to prevent damaging them during the
procedure). Then, close the door.
2. Remove the top hinge cap (1). Be particularly careful not to damage
the connector (A). Unplug the connector (A).
3. Undo the screws (2) and remove the hinge (3). Run the connector
(A) through the hole in the hinge. Hold the door while doing this to
prevent it from falling.
14
To Next Page
Loading...
Need help?
General
