Appliance interior equipment
( * Equipment depends on the model)
Shelf
You can lay out the empty shelves to your liking across the guides in the
refrigerator interior without having to remove them from the refrigerator.
To move the shelf or take it out from the refrigerator, slightly lift it at the
back, pull it towards you, and then either move it or take it out of the
appliance. Store quickly perishable food at the back of the shelf where
the temperature is the lowest.
Wire bottle rack *
• Some models also feature a wire bottle holder. It is protected against
being inadvertently pulled out. It can only be pulled out when it is
empty. To pull it out, lift it slightly at the front and pull it towards you.
Place the bottle holder so that the length of the bottles does not
prevent proper closing of the door.
The holder can take a maximum load of nine 0.75-litre bottles or 13
kilograms of total weight – see label on the right side in the appliance
interior.
• Cans may also be placed on the bottle rack (lengthwise or crosswise).
Fruit and vegetable bin with humidity control (CrispZone) *
• The drawer at the bottom of the refrigerator is intended for storing fruit and vegetables. It provides
humidity and prevents the food from drying out.
• The humidity in the drawer is regulated automatically, depending on the type and amount of
inserted food.
• Pulling out the bin:
- Pull out the bin as far as it will go. Then, lift the front part and
pull it out completely.
FreshZone/ZeroZone drawer *
(Only in some models)
The FreshZone/ZeroZone compartment allows storing a wide variety of fresh food for up to three
times longer than in a conventional refrigerator. The food stays fresh longer, retaining the flavour and
nutrients. The temperature in this drawer depends on the temperature settings in the refrigerator
compartment, environment temperature, frequency of door opening, and amount of food placed in it.
33
To Next Page
Loading...
Need help?
General
