10.5. SIL9011
The Sil 9011 is a third generation HDMI receiver compatible with the HDMI 1.1 specification.
Backwards compatibility with DVI 1.0 allows HDMI systems to connect to existing DVI 1.0
hosts over a single cable.
The Sil 9011 is capable of receiving and outputting 2 to 8 channels of digital audio of up to
192kHz. An industry-standard I
2
S port allows direct connection to low-cost audio DACs. An
S/PDIF port supports up to 96kHz audio.
Silicon Image’s HDMI receivers use the latest generation of PanelLink TMDS core technology.
These PanelLink cores pass all HDMI compliance tests.
10.5.1 Features
x HDMI 1.1, HDCP 1.1 and DVI 1.0 compliant receiver
x Integrated PanelLink core supports:
DTV resolutions (480i/576i/480p/576p/720p/1080i)
PC resolutions (VGA, SVGA, XGA, SXGA, UXGA) up to 165MHz.
x Digital video interface supports video processors:
24-bit and 48-bit RGB/ YCbCr 4:4:4
16/20/24-bit YCbCr 4:2:2
8/10/12-bit YCbCr 4:2:2 (ITU BT.656)
x S/PDIF output supports bothIEC 60958 and IEC 67937 for PCM, Dolby Digital,
DTS digital or any S/PDIF type audio transmission (32-96kHz Fs)
x Four Programmable I
2
S outputs for connection to low-cost audio DACs.
x Sample rates up to 192kHz
x Auto audio error detection with programmable soft mute.
x Integrated HDCP decryption engine for receiving protected audio and video
content
x Pre-programmed HDCP keys provide highest level of key security, simplifies
manufacturing
10.6. 24LC02
10.6.1. General Description
24AA02/24LC02B (24XX02*) is a 2 Kbit Electrically Erasable PROM. The device is
organized as one block of 256 x 8-bit memory with a 2-wire serial interface. Low-voltage
design permits operation down to 1.8V, with standby and active currents of only 1μA
and 1mA, respectively. The 24XX02 also has a page write capability for up to 8 bytes of
data.
10.6.2 Features
x Single supply with operation down to 1.8V
x Low-power CMOS technology
-1mA active current typical
-1μA standby current typical (I-temp)
To Next Page
Loading...
