Hitachi 53SDX20BB - Page 15

15
1.2 I
2
C Parameter List
(1) Adjust Mode OSD
Press INPUT + POWER of control panel.
B CUT 3F
G CUT 3F
R CUT 3F
G DRV 3F
ADJUST MODE XXXXXXXX SERVICE SUB BRT* WHITE BAL G DRV (COOL)* 3F R DRV (COOL)* 3F R CUTOFF (COOL)* 80 G CUTOFF (COOL)* 80 B CUTOFF (COOL) 80 H POSITION* 3F 47 VD-POS(FC) 3F FACT RESET
CH U/D, INPUT
ADJUST MODE SERVICE SUB BRT WHITE BAL G DRV (COOL) 48 R DRV (COOL) 37 R CUTOFF (COOL) 80 G CUTOFF (COOL) 80 B CUTOFF (COOL) 80 H POSITION 12 47 VD-POS(FC) 00 FACT RESET
CH U/D, INPUT
Select SERVICE and press  key
Press EXIT key
(OSD OFF)
CUT OFF ADJUST MODE
ADJUST MODE SERVICE SUB BRT WHITE BAL G DRV (COOL) 3F R DRV (COOL) 3F R CUTOFF (COOL) 80 G CUTOFF (COOL) 80 B CUTOFF (COOL) 80 H POSITION 3F 47 VD-POS(FC) 3F FACT RESET
CH U/D, INPUT
MENU
Select SERVICE and press  key
Press EXIT key
R DRV 3F
MENU
MENU
Select SUB BRT and press  key
Press EXIT key
BRIGHTNESS 80
Press   to adjust
VIDEO SETTINGS (1) CONTRAST : MIN (2) COLOR : MIN
VIDEO SETTINGS (1) CONTRAST : MAX (2) COLOR,TINT,SHARP,BRIGHT:CENER (3) COLOR TEMP : COOL ADJUST (1) Press  
to select the G DRV.,
R DRV., R CUT, G CUT, B CUT. (Initial position G/B DRV). G/B
DRV, B/R DRV select by the DR R
and DR BG.
(2) Press
 
to adjust.
WHITE BALANCE
ADJ. MODE
INPUT + POWER
Only adjust in cool mode.
Only adjust in cool mode.
Only adjust in cool mode.
*: Adjustable data others: Fixed data (be careful not to change)
A
SUB BRIGHT
ADJ. MODE
 
(DEFAULT)