Hitachi airCore 700 - Page 32

28
INSTALLATION & MAINTENANCE MANUAL
7.1.2.5 Sensor Assignment
This function is to assign the specied sensor to the activated zone.
Step1. Select "Sensor Assignment" and press "OK".
Step2. Press "
" or " " to select sensor.
Press "
" or " " to assign sensor to the target zone.
Step3. Press "OK" to save the setting and return to
Zone Installation Menu. Or press "
" to return
to Zone Installation Menu without saving the setting.
NOTES:
•
Sensor name and description
Sensor Name Description
RCS1 Temperature Sensor of primary WRC
RCS2 Temperature Sensor of secondary WRC (optional)
TS1 Remote Sensor 1 connected to ZIB (THM2, optional)
TS2 Remote Sensor 2 connected to ZIB (THM3, optional)
IDUS Inlet Air Temperature Thermistor of IDU
•
If only one wired remote controller is connected or Wi-Fi adapter is connected, sensor "RCS2" will not be
displayed.
•
Multiple sensors can be assigned to one zone.
7.1.2.6 Airow
This function is to set the airow value for each activated zone and
common zone(if available).
Step1. Select "Airow" and press "OK".
Step2. Press "
" or " " to select zone and press "OK" to
Step3.
Or press "
" to return Zone Installation Menu.
Zone Installation Menu
Sensor Assignment
Zone Labeling
Nominate Spill Zone(s)
Common Zone Setup
BackOK Select
Zone ActiIation
(Mon) 16:30
Item Status
RCS 1
Zone 1
RCS  N/A
TS1 N/A
BackOK Confirm
Sensor Assignment
TS
I:9S
N/A
N/A
Name
Be?room 1
Be?room 
Main Room
Hallway
Living Room
Zone Installation Menu
Damper Timing
Minimum Airflow Ratio
Airflow
BackOK Select
Turn On All Zones
Zone
Airflow (L/s)
Z2  Beroom2 275
Z3  LK
123
BackOK Confirm
Airflow
Zone 5
Zone 5
58
78
Z1  Beroom1 378Spill