Hitachi C 10RA2 - Sales Promotion and Safety Guidance; Sales Guidance and Safety Labels

--- 2 ---
4-1. Selling Point Descriptions
(1) Wide table
An extension wing is standard on this machine to give
the table a width of 864 mm (34"). This provides a
wide ripping surface of up to 360 mm (14-5/32") to the
right of the saw blade and up to 400 mm (15-3/4") to
the left of the saw blade when using the rip fence.
(2) High cutting capacity with 255 mm (10") TCT blade
A 255 mm (10") TCT saw blade is standard on this
machine.
Cutting material: Douglas fir
Percentage of water content: 13 to 16 %
Right-angle cutting in 17 seconds.
Using the roughness meter, the roughness
(irregularities in the surface shown in Fig. 2) was
measured by moving the probe in the direction of the
arrow as shown in Fig. 1.
(3) Good work efficiency with electric brake
When the switch is turned off after a cutting operation, the electric brake will stop the saw blade (in about 3 --- 5
seconds). Efficient operation is assured when removing the cut material.
(4) Equipped with a high-power 1,940 W (2.6 hp) motor
The high-power motor facilitates fast cutting operations.
Hitachi C 10RA2 60 x 150 mm material 15 seconds
Fig. 1
Fig. 2
Table 1
Maker/
Model name
HITACHI
C 10RA2
Table 2
Cutting depth of
saw blade
90˚
0 --- 76
(0 --- 3")
45˚
Bevel
11 --- 63
(7/16" ---
2-1/2")
Cut section
Max. surface
roughness
44 µm
Maker/Model name Max. output
HITACHI C 10RA2 1,940 (2.6 hp)
150 mm (5-29/32")
60 mm (2-3/8")
Cutting direction
Saw marks
Surface roughness (max.)
Direction of probe
Surface
roughness (µm)
Table 3
(Unit: mm)
(Unit: mm)
Max. ripping width
To right of saw To left of saw
blade blade
360 400
(14-5/32") (15-3/4")
Maker/
Model name
HITACHI
C 10RA2
(Unit: W)