A
The dust extraction port (A) with 2 1/2" (6.35 cm) size is located
on the back of the table saw. This port can be connected directly
to a dust collection system by connecting the pick up end of the
dust collection hose to the dust port.
CONNECT TO A DUST COLLECTION SYSTEM (Fig. 15)
27
English
WARNING: ALWAYS connect to a dust collection system and
the table saw must be regularly checked for dust
built up and cleaned frequently, otherwise there
is a risk of heat built up and potential fire.
Fig. 15
To Next Page
Loading...
Need help?
General
