Hitachi Compute Blade 2000 User Manual

7-6 Supplementary Notes on Fibre Channel Adapter Function
□ Factory default settings and confirmation of defaults
Parameters of the adapter and their values set at the factory are described below:
No.
.
Setting Description Selectable value Factory
default
1 Enable or Disable BIOS Set whether to enable or disable ROM BIOS. 1: Enable
2: Disable
Disable
2 Change Default ALPA of
this adapter
Set the adapter's ALPA. (HEX) 01 to EF 00
3 Change PLOGI Retry Timer
( +Advanced Option+)
Set the retry interval for PLOGI. 1: 0 msec
2: 50 msec
3: 100 msec
4: 200 msec
000
4 Topology Selection
( +Advanced Option+)
Set the Loop mode. 1: Auto Topology
(Loop First)
2: Auto Topology
(Pt to Pt First)
3: FC-AL
4: Fabric Point to
Point
Auto
Topology
(Loop
First)
5 Enable or Disable Spinup
delay
( +Advanced Option+)
Set whether to enable or disable maximum
3-minute wait time for completion of hard
disk spinup in the disk array unit.
1: Enable
2: Disable
Disable
6 Auto Scan Setting
( +Advanced Option+)
The setting in case where there is a bootable
OS. Not supported in this adapter.
1: Autoscan disabled
2: Any first device
3: First LUN 0 device
4: First NOT LUN 0
device
Autoscan
Disabled
7 Enable or Disable EDD 3.0
( +Advanced Option+)
Not supported in this adapter. 1: Enable
2: Disable
Disable
8 Enable or Disable Start
Unit Command
( +Advanced Option+)
Not supported in this adapter. 1: Enable
2: Disable
Disable
9 Enable or Disable
Environment Variable
( +Advanced Option+)
Not supported in this adapter. 1: Enable
2: Disable
Disable
10 Enable or Disable
Auto Boot Sector
( +Advanced Option+)
Set the boot sector (32 or 63) automatically. 1: Enable
2: Disable
Disable
11 Link Speed Selection
( +Advanced Option+)
Set the transfer speed. 0: Auto Select
1: 2 Giga baud
2: 4 Giga baud
3: 8 Giga baud
Auto Select

Hitachi Compute Blade 2000 Specifications

General

Brand	Hitachi
Model	Compute Blade 2000
Category	Server
Language	English