7-14 Supplementary Notes on Fibre Channel Adapter Function
<< Using BIOS Utility version 2.12a13 or higher >>
When you install the OS in the device connected to the SAN boot or port from the port of this Fibre
Channel adapter, set item No. 1 of Adapter's Parameters as "Enable". It is also necessary to register the
boot device from "Configure Boot Devices".
1. Display the [BIOS Utility] screen. Select "Configure Boot Devices".
2. When "Configure Boot Devices" is selected, the following screen appears. Select the boot entry device which is to be registered and
press the [Enter] key.
•
•
•
Tip
To Next Page
Loading...
