Hitachi Compute Blade 500 Series - Product Version; Release Notes; Document Organization; Referenced Documents

Product Version
This document revision applies to management module firmware A0240.
Release Notes
Read the release notes before installing and using this product. They may
contain requirements or restrictions that are not fully described in this
document or updates or corrections to this document.
Document Organization
The table below provides an overview of the contents and organization of this
document. Click the chapter title in the left column to go to that chapter. The
first page of each chapter provides links to the sections in that chapter.
Chapter Description
Chapter 1, Preparing for installation Describes preparing for the installation of the
Compute Blade.
Chapter 2, Initial setup Describes setting up the Compute Blade before use.
Chapter 3, Powering on/off system
unit
Describes procedures to power on/off the system
unit.
Referenced Documents
•
BROCADE manuals
¢
Access Gateway Administrator's Guide
¢
Fabric OS Administrator's Guide
¢
Fabric OS Command Reference Fabric OS Message Reference
¢
Fabric OS Message Reference
¢
Fabric OS MIB Reference
¢
Web Tools Administrator's Guide
Document conventions
The term "Compute Blade" refers to all the models of the Compute Blade,
unless otherwise noted.
This document uses the following typographic conventions:
Convention Description
Regular text bold In text: keyboard key, parameter name, property name,
hardware labels, hardware button, hardware switch.
xiv
Preface
Hitachi Compute Blade 500 Series Getting Started Guide