8. Input logout, and then press Enter.
Brocade 10 Gb/sec DCB switch module initial configuration
Change the system administrator password.
Login
1. Start a terminal emulator to the switch module from the system console,
and then connect IP address that is configured as Management LAN port
configuration on page 2-14.
2. Input <user ID> and <password> in the following Table to login.
Table 2-7 Factory default setting for the system administrator
Item Factory default setting
User ID admin
Password password
Initial setup
2-31
Hitachi Compute Blade 500 Series Getting Started Guide
To Next Page
Loading...
