Management LAN port configuration
Configure the LAN port #0 (MGMT0) of the management module to recognize
the management LAN port of the LAN switch module.
Tip: The following procedure described in this section is an example of
configuring the LAN port #0.
Only IPv4 addresses can connect to the management LAN port of the
management module.
1. Login to the web console of the management module.
Tip: For details of login procedure, see Login on page 2-4
of
Initial setting
procedure on page 2-4 in Management module configuration on page 2-4.
2. The Web console menu is displayed after login, and then click Resources
tab.
3. Click Systems tab.
2-14
Initial setup
Hitachi Compute Blade 500 Series Getting Started Guide
To Next Page
Loading...
