61
7.3 Event Scheduling(continued)
Date/Time Settings (
30
)
• The internal clock’s time may not remain accurate. Using SNTP is
recommended to maintain accurate time (
31).
• Once you turn off the projector in the SAVING mode (
SETUP menu in the
Operating Guide) or the AC power, the current date and time setting is reset.
NOTE
The Date/Time setting can be adjusted via a web browser.
Example: If the IP address of the projector is set to 192.168.1.10:
1) Enter “http://192.168.1.10/” into the address bar of the web browser, and select
Projector Web Control from the selection window.
2) Enter your user name and password, and then click the [OK].
3) Click the [Date/Time Settings] on the main menu and configure each item.
Refer to item 3.1.8 Date/Time Settings (
30) for further information.
4) Click the [Apply] button to save the settings.
7. Other Functions
To Next Page
Loading...
