81
SECURITY menu
Item Description
SECURITY
PASSWORD
CHANGE
(1) Use the ā²/ā¼ buttons on the SECURITY menu
to select SECURITY PASSWORD CHANGE
and press the āŗ button to display the ENTER
NEW PASSWORD box.
(2) Use the ā²/ā¼/ā/āŗ buttons to enter the new password.
(3) Move the cursor to the right side of the
ENTER NEW PASSWORD box and press the
āŗ button to display the NEW PASSWORD
AGAIN box, enter the same password again.
(4)
Move the cursor to the right side of the NEW
PASSWORD AGAIN box and press the āŗ
button and the NOTE NEW PASSWORD box
will be displayed for about 30 seconds, please
make note of the password during this time.
Pressing the ENTER button on the remote control or
āŗ
button on the
projector will close the NOTE NEW PASSWORD box.
⢠Please do not forget your password.
SECURITY menu
(continued on next page)
This projector is equipped with security functions.
From the SECURITY menu, items shown in the table
below can be performed.
To use SECURITY menu: User registration is required
before using the security functions.
Enter to the SECURITY menu
1. Press the āŗ button. The ENTER PASSWORD box will be displayed.
2. Use the ā²/ā¼/ā/āŗ buttons to enter the registered password. The
factory default password is
as follows.
CP-A222WN, CP-A302WN : 6415
CP-AW252WN: 4815
This password can be changed
(
ī
below)
. Move the cursor to the
right side of the ENTER PASSWORD box and press the āŗ button to
display the SECURITY menu.
⢠It is strongly recommended the factory default password to be
changed as soon as possible.
⢠If an incorrect password is input, the ENTER PASSWORD box
will be displayed again. If incorrect password is input 3 times, the
projector will turn off. Afterwards the projector will turn off every time
an incorrect password is input.
3. Items shown in the table below can be performed.
If you have forgotten your password
(1). While the ENTER PASSWORD box is displayed, press and hold
the RESET button on the remote control for about 3 seconds or
press and hold the INPUT button for 3 seconds while pressing the
āŗ button on the projector.
(2). The 10 digit Inquiring Code will be displayed. Contact your dealer
with the 10 digit Inquiring Code. Your password will be sent after
your user registration information is conļ¬rmed.
⢠If there is no key input for about 55 seconds while the Inquiring Code is displayed, the menu will
close. If necessary, repeat the process from (1).