Hitachi CP-RX60 - Filter Time, Service

39
Multifunctional settings
Item
Description
LAMP TIME
The lamp time is the time counted after the last resetting. It is
shown
in the OPTION menu as the use time of the lamp.
Performing this
item resets the time.
Pressing the RESET button on the remote control or the button ►
on the projector for about 3 seconds displays a dialog to make sure.
To perform reset, point at RESET using the button ▲.
RESET

CANCEL
•
Please re
set the lamp time
only when you have replaced the lamp
,
for correct messages about the lamp
.
•
About the lamp
replacement
, please see the section "Lamp"
(

41, 42
)
.
FILTER TIME
The
fi lter time
is the time counted after the last resetting. It is shown
in the OPTION menu as the use time of the
air fi lter
.
Performing this
item resets the time.
Pressing the RESET button on the remote control or the button ►
on the projector for about 3 seconds displays a dialog to make sure.
To perform reset, point at RESET using the button ▲.
RESET

CANCEL
•
Please reset the fi lter time only when you have
cleaned or
replaced the
air fi lter
, for correct messages about the
air fi lter
.
•
About the
caring the air fi lter
,
ple
ase see the section "
Air fi lter
"
(

4
3
)
.
OPTION menu (continued)
LAMP TIME
0
RESET
CANCEL
FILTER TIME
0
RESET
CANCEL