Power ON/OFF
Turning On The Power
WARNING • When the power is ON, a strong light is emitted. Do not look into the
lens or vents of the projector.
• Turn the power on/off in right order. Please power on the projector before
the connected devices. Power off the projector after the connected devices.
NOTE
1
Make sure that the power cord is
firmly and correctly connected to the
projector and outlet.
2
When the lens cap is attached, remove
the lens cap.
3
Set the power switch to [ | ] (ON).
4
Press the STANDBY/ON button of the
projector or the button of the remote
control.
The projector lamp will light up and the POWER
indicator will begin blinking green.
According to a setup, the projector lamp may light
up and the POWER indicator may begin blinking
green, without pressing this button.
When the power is completely on, the indicator will
stop blinking and light green.
The POWER indicator will light orange.
Power switch (ON position)
To Next Page
Loading...
Need help?
General
