1.
1.
Press the VIDEO button to select an input for video signal.
Each time you press the button, the projector switches its
video input port as below.
Press the
DIGITAL button to select an input for digital signal.
Each time you press the button, the projector switches its
digital input port as below.
● While ON is selected for AUTO SEARCH item in OPTION menu, the projector
will keep checking every port sequentially till an input signal is detected (
47
).
If VIDEO button is pushed when COMPUTER IN1 or COMPUTER IN2 port is
selected, the projector will check Component port rst.
● While ON is selected for AUTO SEARCH item in OPTION menu, the projector
will keep checking every port sequentially till an input signal is detected (
47
).
If DIGITAL button is pushed when Component, S-VIDEO, VIDEO 1 or VIDEO 2
port is selected, the projector will check HDMI port rst.
COMPONENT (Y, Cb/Pb, Cr/Pr) S-VIDEO VIDEO 1 VIDEO 2
HDMI
DVI-D
1.
Press the MY SOURCE button on the remote control. The
input signal will be changed into the signal you set as MY
SOURCE(49).
● This function also can use for document camera. Select the input port that
connected the document camera.
Displaying and switching the image
COMPUTER IN1 COMPUTER IN2 BNC
1.
Press the COMPUTER button to select an input port for the
RGB signal.
Each time you press the button, the projector switches its
RGB input port from the current port as below.
●
While ON is selected for AUTO SEARCH item in OPTION menu, the
projector will keep checking every port sequentially till an input signal is
detected
(
47)
. If COMPUTER button is pushed when VIDEO 1, VIDEO
2, S-VIDEO,
Component
, HDMI or DVI-D port is selected, the projector will
check COMPUTER IN1 port rst.
To Next Page
Loading...
